ZeeVee ZyPerUHD60 - Page 53

ZyPerUHD60
Important Notes:
The following command can be used on either an encoder or decoder to check the status of
the a_bridge_en setting. Please note the setting is reversed between an encoder and a
decoder.
astparam g a_bridge_en
This will report back either “y” or “n”
a_bridge_en setting
UHD60 Encoder
UHD60 Decoder
y
Dante Receiver
Dante Transmitter
n
Dante Transmitter
Dante Receiver
Rev: 20231115
Page of 47 77
User Manual