c. Reboot via the Reboot command button
"
3. Set HDMI audio output to the received Dante stream. (RX mode)
a. e e_a_out_src_sel::addon
4. Set HDMI audio output to the native stream received from encoder. (TX or RX mode)
a. e e_a_out_src_sel::native
Encoder Dante Commands
1. Set Encoder to Dante Transmit mode
a. astparam s a_bridge_en n
b. astparam save
c. Reboot via the Reboot command button
2. Audio Select in Transmit mode (Default is Auto)
a. e e_a_input::SOURCE
SOURCE values can be “auto | hdmi | analog”
3. Set Encoder to Dante Receive mode." (Receive Dante and output to UHD60 domain)
a. astparam s a_bridge_en y
b. astparam save
c. Reboot via the Reboot command button
Note: If Encoder is in the Receive mode, the UHD60 will not have any
audio feed to send unless the encoder is actively receiving Dante audio from
another source.
To Next Page
Loading...