PAGE 21
206-03890
EZ Scan continued
Press the MENU button on the remote control, then
use the UP/DOWN arrow button to select the Setup
menu
Press the RIGHT arrow button to access the Setup
menu.
Use the UP/DOWN arrow button to select EZ Scan,
then press the RIGHT arrow button.
Use the UP/DOWN arrow button to select option 1,
2, 3, or 4. (Based on your connection(s) to
Antenna 1-2.)
Press ENTER button to begin the channel search.
Note: Allow EZ Scan to complete the channel
search cycle for TV, CABLE*, DTV, etc.
4
5
6
7
8
Run EZ Scan again after any
Antenna/Cable connection changes.
Mini glossary
TV The antenna device receiving the program signal sent over-the-air.
DTV Digital TV programming sent over-the-air.
CATV Your EZ Scan selection, if you subscribe to a cable service.
CADTV Your EZ Scan selection, if you subscribe to a digital cable service.
*Cable Service Band Note: Select Std=Standard, HRC=HRC Band, or IRC=IRC Band.
For further band information, contact your cable service provider.
To Next Page
Loading...
