PAGE 52
206-03890
Programming the Remote
Test your remote control.
To find out whether your remote control can
operate the component without program-
ming, turn on the component such as a VCR
and press the corresponding mode button
(VCR) on the remote control, while pointing
at the component. Test the POWER and CH
+/- buttons to see if the component
responds properly. If not, the remote
requires programming to operate the device.
Turn on the component to be programmed,
then press the corresponding mode button
on the remote control.
Press the POWER and MUTE buttons simulta-
neously, the remote control is ready to be
programmed for the code.
There are two ways to find the right code for
the component.
A. If you press the CH +/- buttons repeat-
edly, the codes will change one at-a-time.
Press the POWER button after each code
change. If the right code is found, the
device will turn off.
B. Enter a code number using the number
buttons on the remote. Programming code
numbers for the corresponding component
can be found on the following pages.
Again, if the code is correct, the device will
turn off.
Press the EXIT button to store the code.
Test the remote control functions to see if
the component responds properly. If not,
repeat from step 2.
1
2
3
4
5
2
3
4
5
6
4
The remote control for your HD receiver is a
multi-brand or universal remote control. It can
be programmed to operate most remote-con-
trollable devices of other manufacturers.
Note that the remote control may not control
all models of other brands.
3/4
To Next Page
Loading...
