SWT
GIGABIT/FAST ETHERNET SWITCH TYPE SWT 112/137
USER GUIDE - M0SWTA1903Iv09 - V09 March 2019
download This carries out a copy (back up) of the parameters configured in the
equipment, which have a value different from the default value (Factory) to
be carried out. For this reason this command is useful for configuring
equipment with the same parameters as the current one.
Syntax: drn /> download
Arguments: -
Observations: This command can be used irrespective of the directory
where the user is.
The list of commands shown starts with the command
restore, which applies the factory configuration, followed
by the commands required to obtain the current
configuration.
It is a good idea to copy and save this list of commands in
a .txt file, so it can be used in other equipment with the
same characteristics.
To apply the saved configuration in different equipment,
it must be of the same model and version, and above all,
have the same firmware version installed, since the
factory configuration used to generate the commands
list may be different in each one.
Example: drn /> download
get This shows the current values of one or several equipment configuration
parameters.
Syntax: drn /> get [nombre]
Arguments: -
name (optional) name of the parameter to be shown.
Observations: The command get with no argument shows the values of
all the configuration parameters in the current directory
and its subdirectories. If the argument is the name of a
To Next Page
Loading...
