EasyManuals Logo

ZKTeco ProFace X User Manual

ZKTeco ProFace X
97 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #79 background imageLoading...
Page #79 background image
ProFace X (DS) User Manual
Page | 78 Copyright©2022 ZKTECO CO., LTD. All rights reserved.
The Door-unlock combination 2 is set as (02 02 04 04 07), indicating that the unlock
combination 2 consists of 5 people; the first two are from AC group 2, the next two are from AC
group 4, and the last person is from AC group 7.
The Door-unlock combination 3 is set as (09 09 09 09 09), indicating that there are 5 people in
this combination; all of which are from AC group 9.
The Door-unlock combination 4 is set as (03 05 08 00 00), indicating that the unlock
combination 4 consists of only three people. The first person is from AC group 3, the second
person is from AC group 5, and the third person is from AC group 8.
Note: To delete the door-unlock combination, set all the Door-unlock combinations to 0.
Anti-Passback Setup 11.5
A user may be followed by some person(s) to enter the door without verification, resulting in a security
breach. So, to avoid such situations, the Anti-Passback option was developed. Once it is enabled, the
check-in and check-out record must occur alternatively to open the door to represent a consistent pattern.
This function requires two devices to work together:
One device is installed on the indoor side of the door (master device), and the other one is installed on the
outdoor side of the door (the slave device). The two devices communicate via the Wiegand signal. The
Wiegand format and Output type (User ID / Card Number) adopted by the master device and slave device
must be consistent.
Tap Anti-Passback Setup on the Access Control interface.

Table of Contents

Other manuals for ZKTeco ProFace X

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ZKTeco ProFace X and is the answer not in the manual?

ZKTeco ProFace X Specifications

General IconGeneral
TypeFace recognition terminal
IK codeIK04
Face capacity30000
Product colorBlack, Grey
User capacity50000 user(s)
Event capacity1000000
Wiegand interfaceYes
Temperature measurement range34 - 45 °C
Temperature measurement accuracy0.3 °C
Temperature measurement distance30 - 50 cm
International Protection (IP) codeIP68
Operating temperature (T-T)-30 - 60 °C
RS-232 ports1
Screen shapeFlat
Display diagonal8 \
Display technologyLED
Sensor typeCMOS
Camera resolution (numeric)2 MP
Input current2 A
Input voltage12 V
Weight and Dimensions IconWeight and Dimensions
Depth (with stand)26 mm
Width (with stand)143 mm
Height (with stand)227 mm

Related product manuals