Conducting a full test
1. On the Home Screen, use the (selection) dial to select (SD CARD) and press the
(ENTER) button.
The SD Card screen will open.
2. Use the (selection) dial to select “Full Test” and press the (ENTER) button.
The amount of time required for the full test will be shown.
3. Use the (selection) dial to select “Execute” and press the (ENTER) button.
The card performance test will start.
The result of the test will be shown when it completes.
If Access Rate Max. reaches
100％,
the card will fail (NG).
NOTE
Even if a performance test result is "Pass", there is no guarantee that writing errors will not occur. This
information is just to provide guidance.
HINT
During a test, the (ENTER) button can be pressed to stop it.
121
To Next Page
Loading...
