Connecting with an UltraSync BLUE
If the H5studio is connected to an UltraSync BLUE, it can receive timecode from the UltraSync BLUE and
add it to recording files.
To connect an UltraSync BLUE, a BTA-1 or another dedicated wireless adapter must be connected to the
H5studio. Then, the UltraSync BLUE and the H5studio must be paired.
1. With the H5studio power off, remove the REMOTE connector cover on the right side. Then, connect
the BTA-1 or another dedicated wireless adapter.
2. Slide the (POWER/HOLD) switch toward (in the direction of the INPUT 1 and 2 jacks) to
turn on the power.
3. On the Home Screen, use the (selection) dial to select (SYSTEM) and press the
(ENTER) button.
This opens the System Settings Screen.
4. Use the (selection) dial to select “Bluetooth” and press the (ENTER) button.
125
To Next Page
Loading...
