5. Use the (selection) dial to select “Timecode” and press the (ENTER) button.
Searching for the device to connect will begin and “Searching…” will appear on the display.
NOTE
If the H5studio and an UltraSync BLUE have been connected before, make a selection when the following
screen appears.
Setting value Explanation
Paired Device Select this to connect to the UltraSync BLUE that was
connected the previous time.
In this case, connection will be made with the UltraSync BLUE
and its operation described in step 6 becomes unnecessary.
New Device Select this to connect to a different UltraSync BLUE than the
one that was connected the previous time.
Selecting “New Device” will erase information about the
previously paired device. Proceed to step 6.
HINT
Searching can be canceled by pressing the (ENTER) button.
126
To Next Page
Loading...
