Setting the guide sound (first time starting up)
Set the guide sound when a screen to set it is shown the first time the power is turned on after purchase or
after the H5studio has been reset to factory defaults.
1. Use the (selection) dial to select the setting item and press the (ENTER) button.
Setting value Explanation
Voice + Beep Setting items will be read aloud in the installed language. A beeping
sound will be used to notify the occurrence of error messages,
recording starting/stopping and volume adjustment, for example.
English is installed at the time of purchase, but other languages
can be installed and used for reading as desired. (→Installing guide
sounds)
Beep Only A beeping sound will be used to notify when error messages occur,
recording starts/stops and the volume changes, for example. Nothing
will be read aloud.
Off This turns off the guide sound.
After the guide sound setting is confirmed, set the language shown when a screen to set it opens.
(→Setting the language shown (first time starting up))
NOTE
The volume of the guide sound can also be adjusted. (→Setting the guide sound volume)
HINT
• The guide sound setting can also be changed later on the System Settings Screen. (→Setting the guide
sound (Accessibility))
• The guide sound can be turned on/off immediately by pressing and holding the (ENTER) button
when the Home Screen is open. (→Turning the guide sound on/off with a shortcut)
41
To Next Page
Loading...
