Supplying power
The H5studio can operate using batteries or a power supply connected to the USB port (AC adapter, USB
bus power or portable battery).
Power from a power supply connected to the USB port will be used before batteries.
Installing batteries
To power the H5studio with batteries, use 4 AA batteries.
1. When the power is off, push the latches up to open the battery cover.
2. Install 4 AA batteries.
Spread the ribbon under the batteries.
3. Replace the battery cover.
NOTE
• Use only one type of battery (alkaline, NiMH or lithium) at a time.
• Set the type of battery used correctly so that the amount of remaining battery charge can be shown
accurately. (→Setting the type of batteries used)
• If the batteries run out of charge, turn the power off immediately and install new batteries. The battery
charge will always be shown when operating on battery power.
33
To Next Page
Loading...
