6. Operate the UltraSync BLUE and select the H5studio as a connected device.
This starts pairing.
When pairing completes, “Timecode device connected” will appear on the H5studio display.
HINT
• See the UltraSync BLUE manual for the procedures to select connected devices.
• Use the H5studio and the UltraSync BLUE as close together as possible to make communication more
reliable.
• If communication with the UltraSync BLUE is interrupted while recording, timecode data will not be
added to the remainder of the recording.
• If communication occurred previously with an UltraSync BLUE, reconnection will occur automatically with
that UltraSync BLUE after step 2.
Checking timecode data
While timecode is being received from an UltraSync BLUE, timecode data can be checked on the Home
Screen.
The timecode appears above the recordable time on the Home Screen as the hour, minute, second and
frame.
❶
Hour
❷
Minute
❸
Second
❹
Frame
Disconnecting from an UltraSync BLUE
Removing the BTA-1 from the H5studio will disconnect the H5studio from the UltraSync BLUE and stop
timecode recording. Pairing information will be retained even when disconnected.
127
To Next Page
Loading...
