Zoom H5studio - Page 20

❻
Waveform display (MIC capsule, INPUT 1/2)
This shows the waveforms of the signals being recorded on the tracks.
The input types are shown at the left end of each waveform.
• : Mic capsule L/R
• : INPUT 1
• : INPUT 2
The following will be shown when a track is off. (→Enabling tracks for recording)
The following will be shown when a track is stereo. (→Enabling stereo linking)
❼
Level meters (MIC (mic capsule), INPUT 1/2, stereo mix)
This shows the levels of the signals being input on the tracks.
When the recording mode is “16/24bit Fixed”, clipping indicators will be shown at the tops of the level
meters if input signals clip. (→Setting the recording mode)
Peak values are shown at the bottom of the level meters.
From the left, the level meters are for the MIC (mic capsule), INPUT1, INPUT2 and stereo mix tracks.
The stereo mix track might not be shown depending on the settings. (→Setting whether to record mix
files)
The input types are shown at the bottom of each level meter.
• : Mic capsule L/R
• : INPUT 1 with input level set to mic and phantom on.
• : INPUT 2 with input level set to line and phantom off.
The following will be shown when a track is off. (→Enabling tracks for recording)
20