Selecting the bit depth
The bit depth of recorded files can be set.
This can only be set when the recording mode is “16/24-bit Fixed”. (→Setting the recording mode)
1. On the Home Screen, use the (selection) dial to select (REC) and press the
(ENTER) button.
This opens the Rec Settings Screen.
2. Use the (selection) dial to select “Bit Depth” and press the (ENTER) button.
3. Use the (selection) dial to select the bit depth and press the (ENTER) button to confirm.
The following bit depths can be selected.
16-bit, 24-bit
NOTE
When the recording mode is “32-bit Float”, the bit depth is always 32-bit float.
73
To Next Page
Loading...
