4. Select whether or not to export using a specified range.
Use the (selection) dial to select “Range” and press the (ENTER) button. Then, use the
(selection) dial to select the setting and press the (ENTER) button.
Setting value Explanation
A-B This exports the range between the two points set using Repeating
playback of a set interval (A-B repeat).
All This exports the entire track.
5. Select whether or not to normalize.
Use the (selection) dial to select “Normalize” and press the (ENTER) button. Then, use
the (selection) dial to select “On” or “Off” and press the (ENTER) button.
If “On” is selected, the file will be normalized during export.
NOTE
Normalization is a function that reads the maximum volume of the audio data and levels the volume without
causing distortion. The volume is adjusted to the maximum possible without causing the loudest sound
(peak) in the data to distort.
96
To Next Page
Loading...
