ZyXEL Communications EMG3425-Q10A - Page 113

Chapter 14 Static Route
EMG3425-Q10A User’s Guide
113
The following table describes the labels in this screen.
Table 45 Network > Static Route: Add/Edit
LABEL DESCRIPTION
Static Route Select to enable or disable this rule.
Route Name Type a name to identify this rule. You can use up to 31 printable English keyboard
characters, including spaces.
Destination IP
Address
This parameter specifies the IP network address of the final destination. Routing is always
based on network number. If you need to specify a route to a single host, use a subnet
mask of 255.255.255.255 in the subnet mask field to force the network number to be
identical to the host ID.
IP Subnet Mask Enter the IP subnet mask here.
Use Gateway IP
Address
Select to enable or disable this rule.
Gateway IP
Address
Enter the IP address of the next-hop gateway. The gateway is a router or switch on the
same segment as your EMG3425-Q10A's interface(s). The gateway helps forward packets
to their destinations.
Use Interface Select a WAN interface through which the traffic is sent. You must have the WAN
interface(s) already configured in the WAN screens.
Back Click Back to return to the previous screen without saving.
Apply Click Apply to save your changes back to the EMG3425-Q10A.
Cancel Click Cancel to set every field in this screen to its last-saved value.