Chapter 21 Remote Management
EMG3425-Q10A User’s Guide
148
2 There is already another remote management session. You may only have one remote
management session running at one time.
3 There is a firewall rule that blocks it.
21.3.1 Remote Management and NAT
When NAT is enabled:
• Use the EMG3425-Q10A’s WAN IP address when configuring from the WAN.
• Use the EMG3425-Q10A’s LAN IP address when configuring from the LAN.
21.3.2 System Timeout
There is a default system management idle timeout of five minutes (three hundred seconds). The
EMG3425-Q10A automatically logs you out if the management session remains idle for longer than
this timeout period. The management session does not time out when a statistics screen is polling.
You can change the timeout period in the Maintenance > General screen
21.4 WWW Screen
To change your EMG3425-Q10A’s remote management settings, click Configuration >
Management > Remote MGMT to open the WWW screen.
To Next Page
Loading...
