Chapter 22 Universal Plug-and-Play (UPnP)
EMG3425-Q10A User’s Guide
159
All UPnP-enabled devices may communicate freely with each other without additional configuration.
Disable UPnP if this is not your intention.
22.3 UPnP Screen
Use this screen to enable UPnP on your EMG3425-Q10A.
Click Management > UPnP to display the screen shown next.
Figure 89 Management > UPnP
The following table describes the fields in this screen.
22.4 Technical Reference
The sections show examples of using UPnP.
22.4.1 Using UPnP in Windows XP Example
This section shows you how to use the UPnP feature in Windows XP. You must already have UPnP
installed in Windows XP and UPnP activated on the EMG3425-Q10A.
Make sure the computer is connected to a LAN port of the EMG3425-Q10A. Turn on your computer
and the EMG3425-Q10A.
22.4.1.1 Auto-discover Your UPnP-enabled Network Device
1 Click start and Control Panel. Double-click Network Connections. An icon displays under
Internet Gateway.
2 Right-click the icon and select Properties.
Table 68 Management > UPnP
LABEL DESCRIPTION
UPnP Select Enable to activate UPnP. Be aware that anyone could use a UPnP application to
open the web configurator's login screen without entering the EMG3425-Q10A's IP
address (although you must still enter the password to access the web configurator).
Apply Click Apply to save the setting to the EMG3425-Q10A.
Cancel Click Cancel to return to the previously saved settings.
To Next Page
Loading...
