Chapter 5 Access Point Mode
EMG3425-Q10A User’s Guide
35
5.4.1 Navigation Panel
Use the menu in the navigation panel to configure EMG3425-Q10A features in Access Point Mode.
Figure 15 Menu: Access Point Mode
Refer to Table 8 on page 28 for descriptions of the labels shown in the navigation panel.
5.5 LAN Screen
Use this section to configure your LAN settings while in Access Point Mode.
Click Network > LAN to see the screen below.
Note: If you change the IP address of the EMG3425-Q10A in the screen below, you will
need to log into the EMG3425-Q10A again using the new IP address.
- CPU Usage This displays what percentage of the EMG3425-Q10A’s processing ability is currently used.
When this percentage is close to 100%, the EMG3425-Q10A is running at full load, and the
throughput is not going to improve anymore. If you want some applications to have more
throughput, you should turn off other applications (for example, using bandwidth
management.)
- Memory Usage This shows what percentage of the heap memory the EMG3425-Q10A is using.
Interface Status
Interface This displays the EMG3425-Q10A port types. The port types are: LAN and WLAN.
Status For the LAN ports, this field displays Down (line is down) or Up (line is up or connected).
For the 2.4GHz/5GHz WLAN, it displays Up when the 2.4GHz/5GHz WLAN is enabled or
Down when the 2.4G/5G WLAN is disabled.
Rate For the LAN ports, this displays the port speed and duplex setting or N/A when the line is
disconnected.
For the 2.4GHz/5GHz WLAN, it displays the maximum transmission rate when the 2.4GHz/
5GHz WLAN is enabled and N/A when the WLAN is disabled.
Table 9 Status Screen: Access Point Mode (continued)
LABEL DESCRIPTION
To Next Page
Loading...
