Chapter 8 WAN
EMG3425-Q10A User’s Guide
60
The following table describes the labels in this screen.
8.4.1 Add/Edit WAN Connection
Click the Add New WAN Entries in the Configuration > WAN screen or the Edit icon next to
theconnection you want to configure. Use this screen to configure a WAN connection. The screen
varies depending on the encapsulation you select.
8.4.1.1 IPoE Encapsulation
This screen displays when you select IPoE encapsulation.
Table 15 Network > WAN > Management WAN
LABEL DESCRIPTION
Add New WAN
Entries
Click this to create a new WAN interface entry.
# This is the index number of the connection.
Default Select the WAN interface that you want to configure as default.
Name This is the service name of the connection.
Interface This is the interface of the connection.
Type This shows the type of interface used by this connection.
VLAN ID This indicates the VLAN ID number assigned to traffic sent through this connection.
IP Address This is the WAN IP address used by this connection.
Status This shows the status of the connection.
Modify Click the Edit icon to configure the connection.
Click the Delete icon to delete this connection from the EMG3425-Q10A. A window
displays asking you to confirm that you want to delete the connection.
To Next Page
Loading...
