Chapter 21 Remote Management
EMG3425-Q10A User’s Guide
154
21.7 Wake On LAN Screen
Wake On LAN (WoL) allows you to remotely turn on a device on the network, such as a computer,
storage device or media server. To use this feature the remote hardware (for example the network
adapter on a computer) must support Wake On LAN using the “Magic Packet” method.
You need to know the MAC address of the remote device. It may be on a label on the device.
Use this screen to remotely turn on a device on the network. Click the Configuration >
Management > Remote MGMT > Wake On LAN to open the following screen.
Figure 87 Configuration > Management > Remote MGMT > Wake On LAN
Server Access Select the interface(s) through which a computer may access the EMG3425-Q10A using
this service.
Secured Ip Select All to allow all computers to access the EMG3425-Q10A.
Otherwise, check Selected and specify the IP address of the computer that can access
the EMG3425-Q10A.
SNMP Enable Select this to enable SNMP on this device.
Get Community Enter the SNMP get community information here.
Set Community Enter the SNMP set community information here.
System Location Enter the SNMP system location.
System Contact Enter the SNMP system contact.
Trap Settings
Trap Enable Select this to enable trap settings on this device.
Trap Manager IP Type the IP address of the station to send your SNMP traps to.
Trap Community Type the trap community, which is the password sent with each trap to the SNMP
manager. The default is public and allows all requests.
Apply Click Apply to save your customized settings and exit this screen.
Reset Click Reset to begin configuring this screen afresh.
Table 65 Configuration > Management > Remote MGMT > SNMP (continued)
LABEL DESCRIPTION
To Next Page
Loading...
