Chapter 15 Interface Group
EMG3425-Q10A User’s Guide
116
15.2.2 Add Interface Group Criteria
Click the Add button in the Interface Group screen to open the following screen.
Figure 69 Interface Group > Add New Group > Add Interface Group Criteria
The following table describes the fields in this screen.
# This shows the index number of the rule.
Filter Criteria This shows the filtering criteria. The LAN interface on which the matched traffic
is received will belong to this group automatically.
Back Click this button to return to the previous screen without saving any changes.
Apply Click this button to save your settings back to the EMG3425-Q10A.
Cancel Click Cancel to begin configuring this screen afresh.
Table 47 Interface Group > Add New Group
LABEL DESCRIPTION
Table 48 Interface Group > Add New Group > Add Interface Group Criteria
LABEL DESCRIPTION
DHCP Option 60 Select this option and enter the Vendor Class Identifier (Option 60) of the
matched traffic, such as the type of the hardware or firmware.
Vendor ID Enter the identification number assigned to the company by the IANA (Internet
Assigned Numbers Authority).
Apply Click this button to save your settings back to the EMG3425-Q10A.
Cancel Click Cancel to begin configuring this screen afresh.
To Next Page
Loading...
