Chapter 23 USB Media Sharing
EMG3425-Q10A User’s Guide
169
23.7 FTP Screen
Use this screen to set up file sharing via the EMG3425-Q10A using FTP and create user accounts.
Click Management > USB Media Sharing > FTP.
Figure 103 Management > USB Media Sharing > FTP
The following table describes the labels in this screen.
Enable This field displays whether a user account is activated or not. Select the check box to
enable the account. Clear the check box to disable the account.
User Name Enter a user name that will be allowed to access the shared files. You can enter up to 20
characters. Only letters and numbers allowed.
Password Enter the password used to access the shared files. You can enter up to 20 characters.
Only letters and numbers are allowed. The password is case sensitive.
USB1/2 Select the USB port(s) of the EMG3425-Q10A. The configured user can access the files
on the USB device(s) connected to the selected USB port(s) only.
Apply Click Apply to save your changes back to the EMG3425-Q10A.
Cancel Click Cancel to begin configuring this screen afresh.
Table 70 Management > USB Media Sharing > SAMBA (continued)
LABEL DESCRIPTION
Table 71 Management > USB Media Sharing > FTP
LABEL DESCRIPTION
Enable FTP Select this to enable the FTP server on the EMG3425-Q10A for file sharing using FTP.
Port You may change the server port number for FTP if needed, however you must use the
same port number in order to use that service for file sharing.
User Accounts Before you can share files you need a user account. Configure the following fields to set
up a file-sharing account.
# This is the index number of the user account.
To Next Page
Loading...
