Chapter 21 Remote Management
EMG3425-Q10A User’s Guide
151
21.5 Telnet Screen
To change your EMG3425-Q10A’s remote management settings, click Management > Remote
MGMT > Telnet to open the Telnet screen.
Figure 84 Configuration> Management > Remote MGMT > Telnet
The following table describes the labels in this screen.
Table 64 Configuration > Management > Remote MGMT > Telnet
LABEL DESCRIPTION
Port You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
Access Status This field displays the interface through which a computer may access the
EMG3425-Q10A using this service.
Secured Client IP
Address
Select Enable ALL to allow all computers to access the EMG3425-Q10A using the
HTTPS service. Otherwise, select Disable ALL.
Or you can select Trust Domain to specify the IP address/domain of the computer
that can access the EMG3425-Q10A. Click Add to add the IP address/domain to
the trust domain.
Trust Domain
This is available only when you select Trust Domain in the Secured Client IP Address field.
# This displays the index number of the trust domain.
IP Address/Domain This field displays the IP address/domain.
Modify Click the Edit icon to go to the screen where you can edit the IP address/domain.
Click the Delete icon to delete an existing IP address/domain.
Access Status This field displays the interface through which a computer may access the
EMG3425-Q10A using this service.
Secured Client IP
Address
Select Enable ALL to allow all computers to access the EMG3425-Q10A using the
HTTPS service. Otherwise, select Disable ALL.
Or you can select Trust Domain to specify the IP address/domain of the computer
that can access the EMG3425-Q10A. Click Add to add the IP address/domain to
the trust domain.
To Next Page
Loading...
