Chapter 25 Maintenance
EMG3425-Q10A User’s Guide
183
25.8 Restart Screen
System restart allows you to reboot the EMG3425-Q10A without turning the power off.
Click Maintenance > Restart to open the following screen.
Figure 112 Maintenance > Restart
Click Restart to have the EMG3425-Q10A reboot. This does not affect the EMG3425-Q10A's
configuration.
25.9 System Operation Mode Overview
The Sys OP Mode (System Operation Mode) function lets you configure your EMG3425-Q10A as an
router or access point. You can choose between Router or Access Point Mode depending on your
network topology and the features you require from your device.
The following describes the device modes available in your EMG3425-Q10A.
Router
A router connects your local network with another network, such as the Internet. The router has
two IP addresses, the LAN IP address and the WAN IP address.
Figure 113 LAN and WAN IP Addresses in Router Mode
Access Point
An access point enabled all ethernet ports to be bridged together and be in the same subnet. To
connect to the Internet, another device, such as a router, is required.
To Next Page
Loading...
