Chapter 10 LAN
EMG3425-Q10A User’s Guide
92
10.7 IGMP Snooping Screen
Use this screen to enable IGMP Snooping and configure IGMP mode. Click Network > LAN >
IGMP Snooping.
Figure 51 Network > LAN > IGMP Snooping
The following table describes the labels on this screen.
Autoconfiguration
Type
Select SLAAC + RDNSS to enable IPv6 stateless auto-configuration on this interface.
The interface will generate an IPv6 IP address itself from a prefix obtained from an IPv6
router in the network.
Select SLAAC + Stateless DHCPv6 to enable IPv6 stateless auto-configuration on this
interface. The interface will get an IPv6 address from an IPv6 router and the DHCP
server. The IP address information gets through DHCPv6.
Select Stateful DHCPv6 to allow a DHCP server to assign and pass IPv6 network
addresses, prefixes and other configuration information to DHCP clients.
Static IP Address
Select this option to manually enter an IPv6 address if you want to use a static IP address.
LAN IPv6 Address Enter the LAN IPv6 address you want to assign to your EMG3425-Q10A in hexadecimal
notation.
LAN IPv6 Prefix
Length (48~64)
Enter the 48 to 64 address prefix length to specify in an IPv6 address compose the
network address.
Prefix Preferred
Lifetime
Enter the preferred lifetime for the prefix.
Prefix Valid Lifetime Enter the valid lifetime for the prefix.
Link Local Only
Select this option to only use the link local address on the EMG3425-Q10A interfaces in the LAN.
ULA
Select this option to identify a unique local address of the EMG3425-Q10A in the LAN.
Apply Click Apply to save your changes with the EMG3425-Q10A.
Cancel Click Cancel to begin configuring this screen afresh.
Table 33 Network > LAN > IPv6 LAN (continued)
LABEL DESCRIPTION
Table 34 Network > LAN > IGMP Snooping
LABEL DESCRIPTION
IGMP Snooping
To Next Page
Loading...
