EMG3425-Q10A User’s Guide
114
CHAPTER 15
Interface Group
15.1 Overview
By default, all LAN and WAN interfaces on the EMG3425-Q10A are in the same group and can
communicate with each other. Each group acts as an independent network on the EMG3425-Q10A.
15.2 The Interface Group Screen
You can manually add a LAN and/or WLAN interface to a new group. Click Network > Interface
Group to open the following screen.
Figure 67 Network > Interface Group
The following table describes the fields in this screen.
Table 46 Network > Interface Group
LABEL DESCRIPTION
Add Click this to add a new interface grouping rule.
You must configure a WAN connection before you can add a new interface
grouping rule. See Chapter 8 on page 57 for more information.
Interface Grouping Rules
Name This shows the descriptive name of the group.
WAN Interface This shows the WAN interfaces in the group.
LAN Interfaces This shows the LAN and/or WLAN interfaces in the group.
Criteria This shows the filtering criteria for the goup.
Delete Click the Delete icon to remove the group.
To Next Page
Loading...
