GS-4012F User’s Guide
174 Chapter 30 VRRP
30.2 Viewing VRRP Status
Click IP Application, VRRP in the navigation panel to display the VRRP Status screen as
shown next.
Figure 88 VRRP Status
The following table describes the labels in this screen.
Table 67 VRRP Status
LABEL DESCRIPTION
Index This field displays the index number of a rule.
Active This field displays whether a rule is enabled (Yes) or disabled (No).
Network This field displays the IP address and the subnet mask bits of an IP routing domain
that is associated to a virtual router.
VRID This field displays the ID number of the virtual router.
VR Status This field displays the status of the virtual router.
This field is Master indicating that the GS-4012F functions as the master router.
This field is Backup indicating that the GS-4012F functions as a backup router.
This field displays Init when the GS-4012F is initiating the VRRP protocol or when the
Uplink Status field displays Dead.
Uplink Status This field displays the status of the link between the GS-4012F and the uplink
gateway.
This field is Alive indicating that the link between the GS-4012F and the uplink
gateway is up. Otherwise, this field is Dead.
This field displays Probe when the GS-4012F is check for the link state.
Poll Interval(s) The text box displays how often (in seconds) this screen refreshes. You may change
the refresh interval by typing a new number in the text box and then clicking Set
Interval.
Stop Click Stop to halt system statistic polling.
To Next Page
Loading...
