ZyXEL Communications GS-4012F - Egress Set; Figure 174 Wrr Command Example; Figure 175 Egress Set Command Example; Qos Priority

GS-4012F User’s Guide
264 Chapter 40 Command Examples
Figure 174 wrr Command Example
40.8.12 egress set
Syntax:
egress set <port-list>
where
An example is shown next.
• Enable port-based VLAN tagging on the switch.
• Enable ports one, three, four and five for configuration.
• Set the outgoing traffic ports as the CPU (0), seven (7), eight (8) and nine (9).
Figure 175 egress set Command Example
40.8.13 qos priority
Syntax:
qos priority <0 .. 7>
where
An example is shown next.
• Enable ports one, three, four and five for configuration.
• Set the IEEE 802.1p quality of service priority as four (4).
ras# configure
ras(config)# interface port-channel 2,6-12
ras(config-interface)# wrr
ras(config-interface)# wrr 8 7 6 5 4 3 2 1
<port-list>
Sets the outgoing traffic port list for a port-based VLAN.
ras(config)# vlan-type port-based
ras(config)# interface port-channel 1,3-5
ras(config-interface)# egress set 0,7-9
<0 .. 7>
Sets the quality of service priority for a port.