GS-4012F User’s Guide
242 Chapter 39 Introducing the Commands
Table 91 interface port-channel Commands
COMMAND DESCRIPTION
interface
port-channel
<port-list>
Enables a port or a list of ports
for configuration.
bandwidth-limit
Enables bandwidth control on
the port(s).
egress <Mbps>
Sets the maximum bandwidth
allowed for outgoing traffic on
the port(s).
ingress <Mbps>
Sets the maximum bandwidth
allowed for incoming traffic on
the port(s).
bpdu-control
<peer|tunnel|discard
|network>
Sets how Bridge Protocol Data
Units (BPDUs) are used in STP
port states.
broadcast-limit
Enables broadcast storm
control limit on the switch.
<pkt/s>
Sets how many broadcast
packets the interface receives
per second.
diffserv
Enables DiffServ on the port(s).
dlf-limit
Enables the Destination Lookup
Failure (DLF) limit.
<pkt/s>
Sets the interface DLF limit in
packets per second (pps).
egress set <port-
list>
Sets the outgoing traffic port list
for a port-based VLAN.
exit
Exits from the interface port-
channel command mode.
flow-control
Enables interface flow control.
Flow control regulates
transmissions to match the
bandwidth of the receiving port.
frame-type
<all|tagged>
Choose to accept both tagged
and untagged incoming frames
or just tagged incoming frames
on a port.
gvrp
Enables this function to permit
VLAN groups beyond the local
switch.
help
Displays a description of the
interface port-channel
commands.
inactive
Disables the specified port(s) on
the switch.
To Next Page
Loading...
