ZyXEL Communications GS-4012F - General Configuration Mode; Table 90 Command Summary: Configuration Mode

GS-4012F User’s Guide
230 Chapter 39 Introducing the Commands
39.9.3 General Configuration Mode
The following table lists the commands in Configuration (or Config) mode.
Table 90 Command Summary: Configuration Mode
COMMAND DESCRIPTION
admin-password <pw-string>
<confirm-string>
Changes the administrator
password.
bandwidth-
control
Enables bandwidth control.
bcp-
transparency
Enables Bridge Control Protocol
(BCP) transparency.
classifier <name> <[packet-
format
<802.3untag|802.3tag
|
EtherIIuntag|EtherII
tag>] [priority <0-
7>] [vlan <vlan-
id>][ethernet-type
<ether-num|ip|ipx|
arp|rarp|
appletalk|decnet|
sna|netbios|dlc>]
[source-mac <src-
mac-addr>] [source-
port <port-num>]
[destination-mac
<dest-mac-addr>]
[dscp <0-63> ] [ip-
protocol <protocol-
num|tcp|udp|icmp|egp
| ospf|rsvp|igmp|
igp|pim|ipsec>
[establish-only]]
[source-ip <src-ip-
addr> [mask-bits
<mask-bits>]]
[source-socket
<socket-num>]
[destination-ip
<dest-ip-addr>
[mask-bits <mask-
bits>]]
[destination-socket
<socket-num>]
[inactive]>
Configures a classifier. A
classifier groups traffic into data
flows according to specific
criteria such as the source
address, destination address,
source port number, destination
port number or incoming port
number.
default-
management
<in-band|out-of-
band>
Specifies through which traffic
flow the switch is to send
packets.
dhcp relay
Enables DHCP relay.