ZyXEL Communications GS-4012F - Enable or Disable Port GVRP; Modify Static VLAN; Figure 185 Frame Type Command Example; Figure 186 no Gvrp Command Example

GS-4012F User’s Guide
272 Chapter 41 IEEE 802.1Q Tagged VLAN Commands
This command sets the specified port to accept all Ethernet frames or only those with an IEEE
802.1Q VLAN tag.
The following example sets ports 1 to 5 to accept only tagged frames.
Figure 185 frame type Command Example
41.5.3 Enable or Disable Port GVRP
Use the gvrp command to enable GVRP on the port(s). Use the no gvrp command to disable
GVRP.
The following example turns off GVRP for ports 1 to 5.
Figure 186 no gvrp Command Example
41.5.4 Modify Static VLAN
Use the following commands in the config-vlan mode to configure the static VLAN table.
Syntax:
vlan <vlan-id>
fixed <port-list>
forbidden <port-list>
name <name-str>
normal <port-list>
untagged <port-list>
no fixed <port-list>
no forbidden <port-list>
no untagged <port-list>
where
•Enter
fixed to register the <port-list> to the static VLAN table with <vlan-id>.
•Enter
normal to confirm registration of the <port-list> to the static VLAN table with
<vlan-id>.
ras (config)# interface port-channel 1-5
ras (config-interface)# frame-type tagged
ras (config)# interface port-channel 1-5
ras (config-interface)# no gvrp
<vlan-id> =
The VLAN ID [1 – 4094].
<name-str> =
A name to identify the SVLAN entry.
<port-list> =
This is the switch port list.