GS-4012F User’s Guide
224 Chapter 39 Introducing the Commands
To enter Enable (or privileged) mode, type enable and enter a password when prompted (the
default is 1234). When you enter the Enable mode, the command prompt changes to the pound
sign (
#).
To enter the configuration mode, type
configuration or config. The Configure mode
command prompt consists of the word “
config” and the pound sign (#). There are various
sub configuration modes: interface, router and VLAN.
• To enter config-vlan mode, type
vlan followed by a number (between 1 to 4094). For
example,
vlan 10 to configure settings for VLAN 10.
• To enter config-interface mode and configure the ports, enter
interface port-
channel
followed by a port number. For example, interface port-channel 10.
• To configure the routing domain, enter
interface route-domain followed by the
domain IP address and subnet mask bits (for example,
interface route-domain
192.168.1.1/24
).
• Use the
router commands to configure the routing protocol settings.
Enter
exit or logout to quit from the current mode or log out from the CLI.
39.7 Using Command History
The switch keeps a list of up to 256 commands(s) you have entered for the current CLI
session. You can use any commands in the history again by pressing the up (y) or down (z)
arrow key to scroll through the previously used commands and press
[ENTER]. Use the history
command to display the list of commands.
Figure 143 CLI: History Command Example
39.8 Saving Your Configuration
After you set the switch settings with the configuration commands, use the write memory
command to save the changes permanently.
Figure 144 CLI: write memory
ras> history
enable
exit
show ip
history
ras>
ras# write memory
To Next Page
Loading...
