ZyXEL Communications GS-4012F - Configure STP; Figure 40 Spanning Tree Protocol: Configuration; Table 23 Spanning Tree Protocol: Configuration

GS-4012F User’s Guide
98 Chapter 11 Spanning Tree Protocol
11.2.1 Configure STP
To configure STP, click the Configuration link in the Spanning Tree Protocol screen as
shown next.
Figure 40 Spanning Tree Protocol: Configuration
The following table describes the labels in this screen.
Poll Interval(s) The text box displays how often (in seconds) this screen refreshes. You may
change the refresh interval by typing a new number in the text box and then
clicking Set Interval.
Stop Click Stop to halt STP statistic polling.
Table 22 Spanning Tree Protocol: Status (continued)
LABEL DESCRIPTION
Table 23 Spanning Tree Protocol: Configuration
LABEL DESCRIPTION
Status Click Status to display the Spanning Tree Protocol Status screen (see Figure 39
on page 97).
Active Select this check box to activate STP. Clear this checkbox to disable STP.