ZyXEL Communications GS-4012F - Traceroute; Enabling RSTP; Figure 152 Traceroute Command Example

GS-4012F User’s Guide
252 Chapter 40 Command Examples
40.4 traceroute
Syntax:
traceroute <ip> [in-band|out-of-band|vlan <vlan-id>][ttl <1-
255>] [wait <1-60>] [queries <1-10>]
where
This command displays information about the route to an Ethernet device. The following
example displays route information to an Ethernet device with an IP address of
192.168.1.100.
Figure 152 traceroute Command Example
40.5 Enabling RSTP
To enable RSTP on a port. Enter spanning-tree followed by the port number and press
[ENTER].
The following example enables RSTP on port 10.
<ip> =
The IP address of an Ethernet device.
[in-band|out-of-
band|vlan <vlan-
id> ]
=
Specifies the network interface or the VLAN ID to which the
Ethernet device belongs.
[ttl <1-255>] =
Specifies the Time To Live (TTL) period.
[wait <1-60>] =
Specifies the time period to wait.
[quesries <1-10>] =
Specifies how many tries the switch performs the traceroute
function.
ras> traceroute 192.168.1.100
traceroute to 192.168.1.100, 30 hops max, 40 byte packet
1:192.168.1.100 (10 ms) (10 ms) (0 ms)
traceroute done: