ZyXEL Communications GS-4012F - No Trunk; No Port-Access-Authenticator; Figure 161 no Trunk Command Example

GS-4012F User’s Guide
256 Chapter 40 Command Examples
40.7.3 no trunk
Syntax:
no trunk <T1|T2|T3|T4|T5|T6>
no trunk <T1|T2|T3|T4|T5|T6> lacp
no trunk <T1|T2|T3|T4|T5|T6> interface <port-list>
where
• An example is shown next.
• Disable trunk one (T1).
• Disable LAPC on trunk three (T3).
• Remove ports one, three, four and five from trunk five (T5).
Figure 161 no trunk Command Example
40.7.4 no port-access-authenticator
Syntax:
no port-access-authenticator
no port-access-authenticator <port-list> reauthenticate
no port-access-authenticator <port-list>
where
An example is shown next.
• Disable authentication on the switch.
• Disable re-authentication on ports one, three, four and five.
• Disable authentication on ports one, six and seven.
<T1|T2|T3|T4|T5|T6>
Disables the trunk group.
<T1|T2|T3|T4|T5|T6> lacp
Disables LACP in the trunk group.
<T1|T2|T3|T4|T5|T6>
interface <port-list>
Removes ports from the trunk group.
ras(config)# no trunk T1
ras(config)# no trunk T3 lacp
ras(config)# no trunk T5 interface 1,3-5
= Disables port authentication on the switch.
<port-list>
reauthenticate
= Disables the re-authentication mechanism on the listed port(s).
<port-list>
= Disables authentication on the listed ports.