GS-4012F User’s Guide
244 Chapter 39 Introducing the Commands
39.9.5 interface route-domain Commands
The following table lists the interface route-domain commands in configuration mode.
pvid <1-4094>
The default PVID is VLAN 1 for
all ports. Sets a PVID in the
range 1 to 4094 for the specified
interface.
qos priority <0 .. 7>
Sets the quality of service
priority for an interface.
speed-duplex <auto|10-half|10-
full|100-half|100-
full|1000-full>
Sets the duplex mode (half or
full) and speed (10, 100 or
1000 Mbps) of the connection
on the interface. Selecting
auto (auto-negotiation) makes
one port able to negotiate with a
peer automatically to obtain the
connection speed and duplex
mode that both ends support.
spq
Sets the port(s) to use Strict
Priority Queuing.
test
Performs an interface loopback
test.
vlan-stacking priority <0-7>
Sets the priority of the specified
port(s) in VLAN stacking.
role <access |
tunnel>
Sets the VLAN stacking port
roles of the specified port(s).
SPVID <1-4094>
Sets the service provider VID of
the specified port(s).
vlan-trunking
Enables VLAN Trunking on
ports connected to other
switches or routers (but not
ports directly connected to end
users) to allow frames
belonging to unknown VLAN
groups to pass through the
switch.
wrr
Sets the port(s) to use Weighted
Round Robin queuing (WRR).
<wt1> <wt2> ...
<wt8>
Sets the interface to use WRR
queuing. A weight value of one
to eight is given to each variable
from
wt1 to wt8.
Table 91 interface port-channel Commands (continued)
COMMAND DESCRIPTION
To Next Page
Loading...
