ZyXEL Communications GS-4012F - Transceiver Removal; Figure 10 Transceiver Installation Example; Figure 11 Installed Transceiver; Figure 12 Opening the Transceivers Latch Example

GS-4012F User’s Guide
Chapter 3 Hardware Overview 45
Figure 10 Transceiver Installation Example
2 Press the transceiver firmly until it clicks into place.
3 The switch automatically detects the installed transceiver. Check the LEDs to verify that
it is functioning properly.
Figure 11 Installed Transceiver
3.1.3.2 Transceiver Removal
Use the following steps to remove a mini-GBIC transceiver (SFP module).
1 Open the transceiver’s latch (latch styles vary).
Figure 12 Opening the Transceiver’s Latch Example
2 Pull the transceiver out of the slot.