GS-4012F User’s Guide
Chapter 3 Hardware Overview 47
3.3 Front Panel LEDs
The LEDs are located on the front panel. The following table describes the LEDs on the front
panel.
Table 2 Front Panel LEDs
LED COLOR STATUS DESCRIPTION
BPS Green Blinking The system is receiving power from the backup power supply.
On The backup power supply is connected and active.
Off The backup power supply is not ready or not active.
PWR Green On The system is turned on.
Off The system is off.
SYS Green Blinking The system is rebooting and performing self-diagnostic tests.
On The system is on and functioning properly.
Off The power is off or the system is not ready/malfunctioning.
ALM Red On There is a hardware failure.
Off The system is functioning normally.
Gigabit Ethernet Ports
1000 Green Blinking The port is sending/receiving data.
On The link to a 1000 Mbps Ethernet network is up.
The link to a 10 Mbps Ethernet network is up when the 100 LED is
on.
Off No Ethernet device is connected to this port or the port is
transmitting at 100 Mbps.
100 Amber Blinking The port is sending/receiving data.
On The link to a 100 Mbps Ethernet network is up.
The link to a 10 Mbps Ethernet network is up when the 1000 LED
is on.
Off No Ethernet device is connected to this port or the port is
transmitting at 1000 Mbps.
Mini-GBIC (SFP) Slots
LNK Green On The port has a successful connection.
Off No Ethernet device is connected to this port.
ACT Green Blinking The port is sending or receiving data.
Off The port is not sending or receiving data.
MGMT Port
10 Green On The link to a 10 Mbps Ethernet network is up.
Blinking The port is receiving or transmitting data. at 10 Mbps.
Off The link to a 10 Mbps Ethernet network is up.
100 Amber On The link to a 100 Mbps Ethernet network is up.
Blinking The port is receiving or transmitting data. at 100 Mbps.
Off The link to a 100 Mbps Ethernet network is up.
To Next Page
Loading...
