ZyXEL Communications GS-4012F - Enable Mode; Table 89 Command Summary: Enable Mode

GS-4012F User’s Guide
226 Chapter 39 Introducing the Commands
39.9.2 Enable Mode
The following table describes the commands available for Enable mode.
ssh <1|2> <[user@]dest-ip>
Connects to an SSH server with the specified SSH version.
traceroute <ip|host-name>
[in-band|out-of-band|vlan
<vlan-id>]
[ttl <1-255>]
[wait <1-60>]
[queries <1-10>]
Determines the path a packet takes to a device.
Table 88 Command Summary: User Mode (continued)
COMMAND DESCRIPTION
Table 89 Command Summary: Enable Mode
COMMAND DESCRIPTION
boot config <index>
Restarts the system with the specified
configuration file.
configure
Accesses Configuration mode. See
Section 39.9.3 on page 230.
copy running-config tftp
<ip> <remote-file>
Backs up running configuration to the
specified TFTP server with the specified
file name.
tftp config <ip>
<remote-file>
Restores configuration with the specified
filename from the specified TFTP server.
flash <ip>
<remote-file>
Restores firmware via TFTP.
disable
Exits Enable (or privileged) mode.
enable
Accesses Enable (or privileged) mode.
erase running-config
Resets to the factory default settings.
exit
Exits Enable (or privileged) mode.
help
Displays help information.
history
Displays a list of command(s) that you
have previously executed.
logout
Exits Enable (or privileged) mode.
mac-flush
Clears the MAC address table.
<port-num>
Removes all learned MAC address on the
specified port(s).
no
logging
Disables syslog logging.
plt <vlan-id>
Disables Packet Loop Test (PLT) on a
VLAN.
<ip> <mask>
Disables Packet Loop Test (PLT) to an
Ethernet device in a VLAN.