ZyXEL Communications GS-4012F - Page 240

GS-4012F User’s Guide
Chapter 39 Introducing the Commands 239
no area <area-id>
virtual-link
<router-id>
authentication-
same-as-area
Resets the authentication
settings on this virtual area.
no area <area-id>
virtual-link
<router-id>
Deletes the virtual link from the
area.
no network <ip-
addr/bits>
Deletes the OSPF network.
no redistribute
rip
Sets the switch not to learn RIP
routing information.
no redistribute
static
Sets the switch not to learn
static routing information.
redistribute rip
metric-type <1|2>
metric <0-65535>
Sets the switch to learn RIP
routing information which will
use the specified metric
information.
redistribute
static metric-
type <1|2> metric
<0-65535>
Sets the switch to learn static
routing information which will
use the specified metric
information.
rip
Enables and enters the RIP
configuration mode.
exit
Leaves the RIP configuration
mode.
vrrp network <ip-
address>/<mask-bits>
vr-id <1-7> uplink-
gateway <ip>
Adds aa new VRRP network nd
enters the VRRP configuration
mode.
inactive
Disables the VRRP settings.
interval <1..255>
Sets the time interval (in
seconds) between Hello
message transmissions.
name <name
string>
Sets a descriptive name of the
VRRP setting for identification
purposes.
no inactive
Activates this VRRP.
no preempt
Disables VRRP preemption
mode.
no primary-
virtual-ip
Resets the network to use the
default primary virtual gateway
(interface IP address).
no secondary-
virtual-ip
Sets the network to use the
default secondary virtual
gateway (0.0.0.0).
preempt
Enables preemption mode.
Table 90 Command Summary: Configuration Mode (continued)
COMMAND DESCRIPTION