Chapter 8 Wireless
NXC Series User’s Guide
128
Activate To turn on an entry, select it and click Activate.
Inactivate To turn off an entry, select it and click Inactivate.
# This field is a sequential value, and it is not associated with a specific entry.
Status This field shows whether or not the entry is activated.
A yellow bulb signifies that this rule is active. A gray bulb signifies that this rule is not active.
UUID This field indicates the UUID to be included in the Bluetooth advertising packets.
Major This field indicates the major number to be included in the Bluetooth advertising packets.
Minor This field indicates the minor number to be included in the Bluetooth advertising packets.
IP Setting
Force Overwrite IP
Setting
Select this to have the NXC change the AP’s IP address setting to match the configuration
in this screen.
Get Automatically Select this to have the AP act as a DHCP client and automatically get the IP address,
subnet mask, and gateway address from a DHCP server.
Use Fixed IP Address Select this if you want to specify the IP address, subnet mask, gateway and DNS server
address manually.
IP Address Enter the IP address for the AP.
Subnet Mask Enter the subnet mask of the AP in dot decimal notation. The subnet mask indicates what
part of the IP address is the same for all devices in the network.
Gateway Enter the IP address of the gateway. The AP sends packets to the gateway when it does not
know how to route the packet to its destination. The gateway should be on the same
network as the AP.
DNS Server IP
Address
Enter the IP address of the DNS server.
VLAN Settings
Override Group
VLAN Setting
Select this option to overwrite the AP VLAN setting with the setting you configure here.
Force Overwrite
VLAN Config
Select this to have the NXC change the AP’s management VLAN to match the
configuration in this screen.
Management VLAN
ID
Enter a VLAN ID for this AP.
As Native VLAN Select this option to treat this VLAN ID as a VLAN created on the NXC and not one assigned
to it from outside the network.
Port Settings
Override Group LAN
Setting
Select this option to overwrite the AP LAN port settings with the settings you configure here.
Port Setting This section displays only when you select Override Group LAN Setting.
Edit Double-click an entry or select it and click Edit to open a screen where you can modify the
entry’s settings. See Section 6.11.2.2 on page 99.
Activate/Inactivate To turn on an entry, select it and click Activate. To turn off an entry, select it and click
Inactivate.
# This is the port’s index number in this list.
Status This displays whether or not the port is activated.
Port This shows the name of the physical Ethernet port on the managed AP.
PVID This shows the port’s PVID.
A PVID (Port VLAN ID) is a tag that adds to incoming untagged frames received on a port
so that the frames are forwarded to the VLAN group that the tag defines.
Table 56 Configuration > Wireless > AP Management > Mgmt. AP List > Edit AP List (continued)
LABEL DESCRIPTION
To Next Page
Loading...
