Chapter 8 Wireless
NXC Series User’s Guide
129
VLAN Configuration This section displays only when you select Override Group LAN Setting.
Add Click this to create a new entry. See Section 6.11.2.3 on page 99.
Edit Double-click an entry or select it and click Edit to open a screen where you can modify the
entry’s settings. See Section 6.11.2.3 on page 99.
Remove To remove an entry, select it and click Remove. The NXC confirms you want to remove it
before doing so.
Activate/Inactivate To turn on an entry, select it and click Activate. To turn off an entry, select it and click
Inactivate.
# This is the VLAN’s index number in this list.
Status This displays whether or not the VLAN is activated.
Name This shows the name of the VLAN.
VID This shows the VLAN ID number.
Member This field displays the Ethernet port(s) that is a member of this VLAN.
Storm Control Setting
Broadcast Storm
Control
Enabling this will drop ingress broadcast traffic in the physical Ethernet port if it exceeds the
maximum traffic rate. The maximum traffic rate can be changed using the CLI (see CLI
Reference Guide).
Multicast Storm
Control
Enabling this will drop ingress multicast traffic in the physical Ethernet port if it exceeds the
maximum traffic rate. The maximum traffic rate can be changed using the CLI (see CLI
Reference Guide).
Rogue AP Detection Setting
Override Group
Rogue AP Detection
Setting
Select this option to overwrite the AP Rogue Detection Settings with the settings you
configure here.
Enable Rogue AP
Detection
Select this option to detect Rogue APs in the network.
LED Suppression Mode Configuration
This section is available only when the AP supports LED suppression mode.
Suppression On Select this option to enable the AP’s LED suppression mode. All the LEDs of the AP will turn
off after the AP is ready.
If the check box is unchecked, it means the LEDs will stay lit after the AP is ready.
Power Setting Enable Force override the power mode to full power if you are using a PoE injector that does
not support PoE negotiation. Otherwise, the AP cannot draw full power from the power
sourcing equipment. Enable this power mode to improve the AP’s performance in this
situation.
Note: Ensure that the power sourcing equipment can supply enough power to
the AP to avoid abnormal system reboots.
Note: Only enable this if you are using a passive PoE injector that is not IEEE
802.3at/bt compliant but can still provide full power.
Locator LED Configuration
This section is available only when the AP has a locator LED.
Turn On/Turn Off When the locator LED is off, click the Turn On button to activate the locator function. It will
show the actual location of the AP between several devices in the network.
If the locator LED is blinking, click the Turn Off button to stop the locator LED from blinking
immediately.
Table 56 Configuration > Wireless > AP Management > Mgmt. AP List > Edit AP List (continued)
LABEL DESCRIPTION
To Next Page
Loading...
