Appendix A Log Descriptions
NXC Series User’s Guide
444
The policy route %d
uses empty source
address group!
Use an empty object group.
%d: the policy route rule number
The policy route %d
uses empty destination
address group!
Use an empty object group.
%d: the policy route rule number
The policy route %d
uses empty service
group
Use an empty object group.
%d: the policy route rule number
Policy-route rule %d
was inserted.
Rules is inserted into system.
%d: the policy route rule number
Policy-route rule %d
was appended.
Rules is appended into system.
%d: the policy route rule number
Policy-route rule %d
was modified.
Rule is modified.
%d: the policy route rule number
Policy-route rule %d
was moved to %d.
Rule is moved.
1st %d: the original policy route rule number
2nd %d: the new policy route rule number
Policy-route rule %d
was deleted.
Rule is deleted.
%d: the policy route rule number
Policy-route rules
were flushed.
Policy routing rules are cleared.
BWM has been
activated.
The global setting for bandwidth management on the NXC has been turned on.
BWM has been
deactivated.
The global setting for bandwidth management on the NXC has been turned off.
Table 213 Built-in Services Logs
LOG MESSAGE DESCRIPTION
User on %u.%u.%u.%u
has been denied access
from %s
HTTP/HTTPS/TELNET/SSH/FTP/SNMP access to the device was denied.
%u.%u.%u.%u is IP address
%s is HTTP/HTTPS/SSH/SNMP/FTP/TELNET
HTTPS certificate:%s
does not exist. HTTPS
service will not work.
An administrator assigned a nonexistent certificate to HTTPS.
%s is certificate name assigned by user
HTTPS port has been
changed to port %s.
An administrator changed the port number for HTTPS.
%s is port number
HTTPS port has been
changed to default
port.
An administrator changed the port number for HTTPS back to the default (443).
HTTP port has changed
to port %s.
An administrator changed the port number for HTTP.
%s is port number assigned by user
Table 212 Policy Route Logs (continued)
LOG MESSAGE DESCRIPTION
To Next Page
Loading...
