ZyXEL Communications NXC Series - Page 450

Appendix A Log Descriptions
NXC Series User’s Guide
450
Table 215 Connectivity Check Logs
LOG MESSAGE DESCRIPTION
Can't open link_up2
Cannot recover routing status which is link-down.
Can not open %s.pid
Cannot open connectivity check process ID file.
%s: interface name
Can not open %s.arg
Cannot open configuration file for connectivity check process.
%s: interface name
The connectivity-
check is activate for
%s interface
The link status of interface is still activate after check of connectivity check
process.
%s: interface name
The connectivity-
check is fail for %s
interface
The link status of interface is fail after check of connectivity check process.
%s: interface name
Can't get gateway IP
of %s interface
The connectivity check process can't get the gateway IP address for the specified
interface.
%s: interface name
Can't alloc memory
The connectivity check process can't get memory from OS.
Can't load %s module
The connectivity check process can't load module for check link-status.
%s: the connectivity module, currently only ICMP available.
Can't handle 'isalive'
function of %s module
The connectivity check process can't execute 'isalive' function from module for
check link-status.
%s: the connectivity module, currently only ICMP available.
Create socket error
The connectivity check process can't get socket to send packet.
Can't get IP address
of %s interface
The connectivity check process can't get IP address of interface.
%s: interface name.
Can't get flags of %s
interface
The connectivity check process can't get interface configuration.
%s: interface name
Can't get NETMASK
address of %s
interface
The connectivity check process can't get netmask address of interface.
%s: interface name
Can't get BROADCAST
address of %s
interface
The connectivity check process can't get broadcast address of interface
%s: interface name
Can't use MULTICAST IP
for destination
The connectivity check process can't use multicast address to check link-status.
The destination is
invalid, because
destination IP is
broadcast IP
The connectivity check process can't use broadcast address to check link-status.
Can't get MAC address
of %s interface!
The connectivity check process can't get MAC address of interface.
%s: interface name
To send ARP REQUEST
error!
The connectivity check process can't send ARP request packet.