ZyXEL Communications NXC Series - Page 451

Appendix A Log Descriptions
NXC Series User’s Guide
451
The %s routing status
seted to DEAD by
connectivity-check
The interface routing can't forward packet.
%s: interface name
The %s routing status
seted ACTIVATE by
connectivity-check
The interface routing can forward packet.
%s: interface name
The link status of %s
interface is inactive
The specified interface failed a connectivity check.
Table 216 NAT Logs
LOG MESSAGE DESCRIPTION
The NAT range is full
The NAT mapping table is full.
%s FTP ALG has
succeeded.
The FTP Application Layer Gateway (ALG) has been turned on or off.
%s: Enable or Disable
Extra signal port of
FTP ALG has been
modified.
Extra FTP ALG port has been changed.
Signal port of FTP ALG
has been modified.
Default FTP ALG port has been changed.
%s H.323 ALG has
succeeded.
The H.323 ALG has been turned on or off. %s: Enable or Disable
Extra signal port of
H.323 ALG has been
modified.
Extra H.323 ALG port has been changed.
Signal port of H.323
ALG has been modified.
Default H.323 ALG port has been changed.
%s SIP ALG has
succeeded.
The SIP ALG has been turned on or off. %s: Enable or Disable
Extra signal port of
SIP ALG has been
modified.
Extra SIP ALG port has been changed.
Signal port of SIP ALG
has been modified.
Default SIP ALG port has been changed.
Register SIP ALG extra
port=%d failed.
SIP ALG apply additional signal port failed.
%d: Port number
Register SIP ALG
signal port=%d failed.
SIP ALG apply signal port failed.
%d: Port number
Register H.323 ALG
extra port=%d failed.
H323 ALG apply additional signal port failed.
%d: Port number
Register H.323 ALG
signal port=%d failed.
H323 ALG apply signal port failed.
%d: Port number
Table 215 Connectivity Check Logs (continued)
LOG MESSAGE DESCRIPTION