Chapter 6 Monitor
NXC Series User’s Guide
87
Keyword Enter a keyword to display the APs that include it in their AP information, such as model
number, firmware version, MAC address and so on. This field is case-sensitive.
Search Click this to update the list of APs based on the search criteria.
Your search criteria is retained when navigating between screens.
Reset Click this to return the search criteria to the factory defaults and display all currently or
previously connected APs without a filter.
Enable Column
Freeze
Select the check box to freeze the first column (#) so it will be always visible when you scroll
through the list. Clear the check box to unfreeze the column.
Edit the selected
rule
Select an AP and click this to change the selected AP’s properties, such as its group, radio,
VLAN and port settings.
Add to Mgmt AP
List
Select an AP and click this to add the selected AP to the managed AP list.
Reboot device Select one or multiple APs and click this button to force the AP(s) to restart.
Remove the
selected rule
Select one or multiple APs and click this button to remove the AP(s) from the manged AP list.
Note: If in the Configuration > Wireless > Controller screen you set the Registration
Type to Always Accept, then as soon as you remove an AP from this list it
reconnects.
DCS Now Select one or multiple APs and click this button to use DCS (Dynamic Channel Selection) to
allow the AP to automatically find a less-used channel in an environment where there are
many APs and there may be interference.
Note: You should have enabled DCS in the applied AP radio profile before the APs
can use DCS.
Note: DCS is not supported on the radio which is working in repeater AP mode.
More Information Select an AP and click this to view a daily station count about the selected AP. The count
records station activity on the AP over a consecutive 24 hour period.
Radio Information Select an online AP and click this button to go to the Monitor > Wireless > AP Information >
Radio List screen to view detailed information about the AP’s radios.
Query Controller
Log
Select one or multiple APs and click this button to go to the Monitor > Log > View Log screen to
view the selected AP’s current log messages.
Nebula Select an AP and click this to open a screen where you can set whether the AP’s IP address
and VLAN settings will be changed when it goes into Nebula cloud management mode. See
Section 6.11.2.4 on page 100.
Note: The AP will be set to Nebula cloud management mode and removed from the
managed AP list right after you click OK.
Upgrade
Firmware Now
Select one or more APs and click this button to update the APs’ firmware version.
Suppression On Select an AP and click this button to enable the AP’s LED suppression mode. All the LEDs of the
AP will turn off after the AP is ready. This button is not available if the selected AP doesn’t
support suppression mode.
Suppression Off Select an AP and click this button to disable the AP’s LED suppression mode. The AP LEDs stay lit
after the AP is ready. This button is not available if the selected AP doesn’t support suppression
mode.
Locator On Select an AP and click this button to run the locator feature. The AP’s Locator LED will start to
blink for 10 minutes by default. It will show the actual location of the AP between several
devices in the network.
Table 36 Monitor > Wireless > AP Information > AP List (continued)
LABEL DESCRIPTION
To Next Page
Loading...
