Chapter 6 Monitor
NXC Series User’s Guide
88
# This is the AP’s index number in this list.
Status This visually displays the AP’s connection status with icons. For details on the different Status
states, see the next table.
Type This indicates whether the AP is on the managed AP list (Mgmt) or not (Un-Mgmt).
This displays Limited when the AP is configured by conflicted or unsupported setting(s).
Description This displays the AP’s associated description. The default description is “AP-” + the AP’s MAC
address.
CPU Usage This displays what percentage of the AP’s processing capability is currently being used.
IP Address This displays the AP’s IP address.
Model This displays the AP’s model number.
This field displays n/a if the NXC cannot get model information from the AP.
Version This displays the AP’s current firmware version.
Group This displays the name of the AP group to which the AP belongs.
The group becomes editable immediately upon clicking.
Station 2.4G This displays the number of stations (aka wireless clients) associated with the AP’s 2.4 GHz WiFi
network.
Station 5G This displays the number of stations (aka wireless clients) associated with the AP’s 5 GHz WiFi
network.
Recent On-line
Time
This displays the most recent time the AP came on-line. N/A displays if the AP has not come on-
line since the NXC last started up.
MAC Address This displays the AP’s MAC address.
Mgmt. VLAN
ID(AC/AP)
This displays the Access Controller (the NXC) management VLAN ID setting for the AP and the
runtime management VLAN ID setting on the AP.
VLAN Conflict displays if the AP’s management VLAN ID does not match the NXC’s
management VLAN ID setting for the AP. This field displays n/a if the NXC cannot get VLAN
information from the AP.
Last Off-line Time This displays the most recent time the AP went off-line. N/A displays if the AP has either not
come on-line or gone off-line since the NXC last started up.
LED Status This displays the AP LED status.
N/A displays if the AP does not support LED suppression mode and/or have a locator LED to
show the actual location of the AP.
A gray LED icon signifies that the AP LED suppression mode is enabled. All the LEDs of the AP will
turn off after the AP is ready.
A green LED icon signifies that the AP LED suppression mode is disabled and the AP LEDs stay lit
after the AP is ready.
A sun icon signifies that the AP’s locator LED is blinking.
A circle signifies that the AP’s locator LED is extinguished.
Ethernet Uplink This field displays the AP’s uplink port speed and duplex mode (Full or Half).
Table 36 Monitor > Wireless > AP Information > AP List (continued)
LABEL DESCRIPTION
To Next Page
Loading...
