Chapter 12 Remote Management
PMG5318-B20A User’s Guide
105
The following table describes the labels in this screen.
12.3 Telnet
You can use Telnet to access the GPON Device’s command line interface. Specify which interfaces
allow Telnet access and from which IP address the access can come.
Click Advanced > Remote MGMT > Telnet tab to display the screen as shown.
Figure 56 Remote Management: Telnet
Table 38 Remote Management: WWW
LABEL DESCRIPTION
Access Status Select the interface(s) through which a computer may access the GPON Device using this
service.
Note: WAN refers to traffic from the Management WAN interface. Traffic from other WAN
interfaces will be dropped.
Secured Client IP A secured client is a “trusted” computer that is allowed to communicate with the GPON
Device using this service.
Select All to allow any computer to access the GPON Device using this service.
Choose Selected to just allow the computer with the IP address that you specify to
access the GPON Device using this service.
Apply Click Apply to save your settings back to the GPON Device.
Cancel Click Cancel to begin configuring this screen afresh.
To Next Page
Loading...
