Chapter 5 LAN
PMG5318-B20A User’s Guide
42
The following table describes the labels in this screen.
5.4 Port Speed
Use this screen to configure your GPON Device’s LAN port speed settings. Click Network > LAN >
Port Speed.
Figure 18 Port Speed
Table 11 Client List
LABEL DESCRIPTION
IP Address Enter the IP address that you want to assign to the computer on your LAN with the MAC
address that you will also specify.
MAC Address Enter the MAC address of a computer on your LAN.
Add Click Add to add a static DHCP entry.
# This is the index number of the static IP table entry (row).
Status This field displays whether the client is connected to the GPON Device.
Host Name This field displays the computer host name.
Interface Type This field displays if the client is connected through ethernet or wireless.
IP Address This field displays the IP address relative to the # field listed above.
MAC Address The MAC (Media Access Control) or Ethernet address on a LAN (Local Area Network) is
unique to your computer (six pairs of hexadecimal notation).
A network interface card such as an Ethernet adapter has a hardwired address that is
assigned at the factory. This address follows an industry standard that ensures no other
adapter has a similar address.
Remaining Lease
Time
This field displays the remaining time for this DHCP lease.
Reserve Select the check box in the heading row to automatically select all check boxes or
select the check box(es) in each entry to have the GPON Device always assign the
selected entry(ies)’s IP address(es) to the corresponding MAC address(es) (and host
name(s)). You can select up to 128 entries in this table.
Apply Click Apply to save your changes back to the GPON Device.
Cancel Click Cancel to begin configuring this screen afresh.
Refresh Click Refresh to reload the DHCP table.
To Next Page
Loading...
